Home > Industry > Bearing performance

Bearing performance

wallpapers Industry 2020-05-12
Hardness is one of the most important qualities of bearing quality, which has direct influence on contact fatigue strength, wear resistance and elastic limit. The hardness of bearing steel should reach HRC61~65 in service condition, so that the bearing can get higher contact fatigue strength and wear resistance.

In order to prevent the bearing parts and finished products from being corroded and rusted in the process of processing, storage and use, it is required that the bearing steel should have good anti-rust performance.

The ability of a bearing to function normally when the centerline of the shaft is tilted relative to the centerline of the bearing seat hole. Double row centripetal spherical ball bearings and double row centripetal spherical roller bearings have good centering performance. The working speed of the roller bearing should be lower than the limit speed. The selection of high-precision bearings, the improvement of the structure and materials of the cage, the use of oil mist lubrication, the improvement of cooling conditions, etc., can increase the limit speed.

The lubrication of the bearing can reduce the internal friction and wear of the bearing and prevent burning and sticking. Prolong its service life; Discharge frictional heat and cooling to prevent overheating of the bearing and aging of the lubricating oil itself; It also has the effect of preventing foreign matters from intruding into the bearing, or preventing rust and corrosion.

When the bearing is working, not only rolling friction but also sliding friction will occur between the ring, the rolling body and the cage, so that the bearing parts will wear away continuously. In order to reduce the wear of bearing parts, maintain the stability of bearing precision and extend the service life, bearing steel should have good wear resistance.

Under the action of periodic load, the contact surface of bearing is easy to fatigue damage, that is, crack and spalling, which is the main form of bearing damage. Therefore, in order to improve the service life of the bearing, the bearing steel must have high contact fatigue strength.

Bearing parts in the production process, to go through a lot of cold, hot processing processes, in order to meet the requirements of large quantities, high efficiency, high quality, bearing steel should have good processing performance. For example, cold, hot molding performance, cutting performance, hardenability and so on.



Suggested Reading:

How to improve the mounting accuracy of bearings.

Bearing selection



Say something
  • All comments(0)
    No comment yet. Please say something!
Tag: bearing